Hot-standby repeater Wall

€8,904.24

Incl. tax

Product code:RP2017/

Dual repeater base with hot-standby protection

Hot-standby means that if a failure occurs - an identical parallel transceiver setup kicks in to maintain communication.

All this is managed by a TP Radio smart-board which monitor:

- Antenna failure
- Antenna cable breach
- Internal radio voltage error
- RX & TX (receive & transmit)

Any of these fails can tell if the repeater base is not functioning and the smart-board will switch the communication to the parallel transceiver for continued TX & RX communication.

The hot-standby repeater base then tells you that it has an error and has switched to safety-mode. This can be reported in two ways:

Beep code sent via TX frequency

Error code via 3 output pins

The repeater base continues to maintain communication and repair can now be planed.

*Freq. Range:

Frequency

* Required Fields

€8,904.24

Incl. tax

Technical Data

Antenna impedance	50 Ohm
Channel Spacing	12,5 / 20 / 25 KHz
Frequency error	± 2 ppm (option +/- 0.1 ppm)
Mode of operation	Duplex
Number of channels	128
Output power	Adjustable high/low in two steps 5 - 25W (40 & 50W available - please contact sales)
RF-bandwidth	60 MHz 70 MHz 38 MHz 20 MHz
Stand-by	0,4 Amps at 13,2 VDC
Temperature range	-25° to + 70°C
Weight	Depending on option
More info	See Download/Datasheet